1:         Ensure that the penetrator is fully retracted by turning handle anti-clockwise before attaching to pipe.

2:         Position saddle valve over straight section of 10mm or 15mm copper pipe.

3:         Insert shim between pipe & screw clamp.

4:         Tighten screw clamp (do not over tighten).

5:         Screw down T-bar handle clockwise.

The saddle valve will now have pierced a hole in the copper pipe.

DO NOT unscrew T-bar handle until the filter is connected.

Faucet

1:         Before drilling a hole for the faucet, ensure that there is unobstructed access underneath the sink / worktop for attachment of the retaining washer & nut.

2:         Using the large black rubber seal as a guide, mark the position you wish to install the faucet.

3:         Drill a 12.5mm hole through the sink / worktop (you may wish to drill a pilot hole first if drilling through stainless steel).

4:         Slide onto the threaded tail of the faucet in this order: small rubber seal, chrome collar & large rubber seal.

5:         From above, insert blue hose into the hole which you have drilled & slide threaded tail through hole until the faucet sits flush on the sink / worktop.

6:         From beneath, slide onto the blue hose & up the threaded tail in this order: large washer, small locking washer & nut.

7:         Tighten nut onto threaded tail until the faucet is fixed securely.

Doulton Filter

1:         Unscrew lower part of filter housing (white) from the top (grey).

2:         Screw filter cartridge into top part of housing.

3:         Screw lower housing back into the top.

4:         Attach the bracket to the top of the housing using the larger screws supplied.

5:         Attach the bracket to a suitable vertical surface (eg side of cupboard) using the smaller screws supplied.

6:         Firmly push red hose from saddle valve into the inlet fitting on the filter housing.

7:         Using the stem reducer, firmly push the blue hose from the faucet into the outlet fitting on the filter housing.

8:         Open the faucet by lifting the lever handle all the way up.

9:         Open the saddle valve by turning the T-bar handle fully anti-clockwise.

10:       Allow the filter to run for 5 minutes before drinking from it.

ACFF Hi-Flo Filter & Pentek QC-10

1:         Using screws (not supplied), attach the bracket to a suitable vertical surface (eg side of cupboard).

2:         Firmly push red hose from saddle valve into the inlet fitting on the filter housing.

3:         Using the stem reducer, firmly push the blue hose from the faucet into the outlet fitting on the filter housing.

4:         Insert filter cartridge into bracket & turn 90 degrees to tighten.

5:         Open the faucet by lifting the lever handle all the way up.

6:         Open the saddle valve by turning the T-bar handle fully anti-clockwise.

7:         Allow the filter to run for 5 minutes before drinking from it.

Silverline UC40HR Filter

1:         Firmly push red hose from saddle valve into the inlet fitting on the pressure control valve (PCV).

2:         Firmly push hose attached to PCV into the inlet (lower) fitting on the filter.

3:         Firmly push the blue hose from the faucet into the outlet (top) fitting on the filter.

4:         Open the faucet by lifting the lever handle all the way up.

5:         Open the saddle valve by turning the T-bar handle fully anti-clockwise.

6:         Allow the filter to run for 5 minutes before drinking from it.

Congratulations, your drinking water filter is now fully installed & ready to use.